2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Microphone Circuit between Microphone and Radio Receiver

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the radio and display receiver assembly.
It also supplies power from the radio and display receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM

B360077E07

INSPECTION PROCEDURE


1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

  1. E280108E18
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-19 (MIN-) - Body ground
    Always
    Below 1 Ω
    H51-18 (SGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H51-4 (MACC) - Body ground
    Engine switch on (ACC)
    4.75 to 5.25 V

    Text in Illustration 
    *a
    Component with harness connected
    (Radio and Display Receiver Assembly)



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Disconnect the W7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-4 (MACC) - W7-11 (MACC)
    Always
    Below 1 Ω
    H51-5 (MIN+) - W7-12 (MCO+)
    Always
    Below 1 Ω
    H51-19 (MIN-) - W7-13 (MCO-)
    Always
    Below 1 Ω
    H51-6 (SNS2) - W7-14 (SNS2)
    Always
    Below 1 Ω
    H51-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    H51-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    H51-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    H51-18 (SGND) - Body ground
    Always
    10 kΩ or higher
    H51-6 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)


← Navigation Voice Circuit (from Aug 2014)Microphone Circuit between Microphone and Radio Receiver (from Aug 2014) →