2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

U0101 Lost Communication with ECM

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

These DTCs are stored when the self-diagnosis of the headlight swivel ECU determines that the CAN communication system is malfunctioning.
DTC Code
DTC Detection Condition
Trouble Area
U0073
Control module communication bus is off.
CAN communication system
U0100
Lost communication with the ECM/PCM "A".
U0101
Lost communication with the ECM.
U0126
Lost communication with the steering angle sensor.
U0129
Lost communication with the skid control ECU.
U0142
Lost communication with the main body ECU (multiplex network body ECU).
U1000
CAN communication failure.
U1121
Lost communication with the driver seat module.

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. for LHD with Entry and Start System

    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

  1. for LHD without Entry and Start System

    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

  1. for RHD with Entry and Start System

    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

  1. for RHD without Entry and Start System

    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

OK:
DTC output does not occur.

Result 
Result
Proceed to
OK
A
NG (for for LHD with Entry and Start System)
B
NG (for for LHD without Entry and Start System)
C
NG (for for RHD with Entry and Start System)
D
NG (for for RHD without Entry and Start System)
E


B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B2452 Height Control Sensor Data Out of Range When Initializing (from Aug 2014)U0101 Lost Communication with ECM (+ 7 more codes) (from Aug 2014) →