2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE SIDE STEP ASSEMBLY LH (for 5 Door)
  1. w/ Illumination:
    Disconnect the 2 connectors.

  1. Remove the 6 bolts and side step.

    B236304


2. REMOVE STABILIZER CONTROL VALVE PROTECTOR

  1. C212853
    Remove the 2 bolts and stabilizer control valve protector.


3. DRAIN SUSPENSION FLUID

  1. C212854
    Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.

    HINT:
    1. Drain suspension fluid when performing operations related to the hydraulic circuits.
    2. Draining suspension fluid decreases suspension fluid pressure.

  1. Tighten the bleeder plug.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }


4. REMOVE REAR STABILIZER LOWER BRACKET

  1. C214450
    Remove the 4 bolts and 2 rear stabilizer lower brackets.


5. REMOVE REAR STABILIZER BAR SUB-ASSEMBLY

  1. C214762
    Remove the 2 bolts, 2 nuts and rear stabilizer bar.

    NOTICE:
    Turn the bolts while holding the nuts.

  1. Remove the 2 stabilizer bushes from the rear stabilizer bar.


6. DISCONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY

  1. C214763
    Remove the 2 union bolts and 2 pressure port gaskets and disconnect the rear stabilizer control tube from the rear stabilizer control cylinder.


7. REMOVE REAR STABILIZER CONTROL CYLINDER

  1. C214764
    Remove the bolt, nut and rear stabilizer control cylinder.

    NOTICE:
    Do not hold the rear stabilizer control cylinder by the cylinder boot.

    HINT:
    Turn the nut while holding the bolt.

  1. Remove the 2 bleeder plug caps from the rear stabilizer control cylinder.


8. REMOVE REAR STABILIZER LINK ASSEMBLY

  1. C214765
    Remove the bolt, nut and rear stabilizer link assembly.

    HINT:
    Turn the nut while holding the bolt.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →