2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

  1. B236472
    Hold down the window deflector.

    NOTICE:
    Make sure that the spring indicated by the arrow in the illustration is securely installed.

  1. B236473E01
    Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.
    Text in Illustration 
    *1
    Protective Tape
    V100135
    Slide

    HINT:
    Tape the screwdriver tip before use.

  1. B236474E01
    Slide the rear roof drip channel forward and attach the 2 claws to install it.
    Text in Illustration 
    *a
    Forward

  1. Install the 2 stoppers with the 2 screws.

    B236467


2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

B236475E01
Text in Illustration 
*1
Matchmark A
*2
Matchmark B
*3
Protective Tape
  1. Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

    HINT:
    Tape the screwdriver tip before use.


3. INSTALL SLIDING ROOF SUNSHADE STOPPER LH

  1. B178631
    Install the stopper.


4. INSTALL SLIDING ROOF SUNSHADE STOPPER RH

HINT:
Use the same procedure described for the LH side.


5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

  1. Insert the sunshade trim into the sliding roof housing.

    B236477E01

    Text in Illustration 
    *a
    Forward
    -
    -

  1. Attach the 4 claws to install the sliding roof piece LH and RH.

  1. Install the 2 screws.


6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
  1. Install the drive gear with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. B236463
    Attach the bracket claw to install the bracket.

← DISASSEMBLY (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →