2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

DATA LIST / ACTIVE TEST

System information · Vehicles built from Aug 2013


READ DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Data List.

  5. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Glass Hatch Courtesy Switch
    Glass hatch courtesy switch signal / ON or OFF
    ON: Glass hatch open
    OFF: Glass hatch closed
    -
    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Washer Switch*
    Level warning switch / ON or OFF
    ON: Fluid volume is less than 550 to 750 cc (33.5 to 45.7 cu.in.)
    OFF: Fluid volume is more than 550 to 750 cc (33.5 to 45.7 cu.in.)
    -
    1. *: w/ Washer Fluid Level Warning System


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Active Test.

  5. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Rear Wiper Power Supply
    WASHER RR relay operation
    ON/OFF
    -
    Head Light Cleaner*
    Headlight cleaner operation
    ON/OFF
    -
    1. *: w/ Headlight Cleaner System

← FAIL-SAFE CHART (from Aug 2013)Washer Signal Circuit (Aug 2013 – Jul 2014) →