2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Washer Signal Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The headlight cleaner control relay receives the windshield washer operation signal.

WIRING DIAGRAM

B246536E01

INSPECTION PROCEDURE


1. CHECK OPERATION
  1. Check the operation of the front wiper and washer system (Click here).

    OK:
    Front wiper and washer system operates normally.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)

  1. E196647E04
    Disconnect the A38 headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A38-5 (FRWA) - Body ground
    Ignition switch ON, front washer switch on
    Below 1 V
    A38-5 (FRWA) - Body ground
    Ignition switch ON, and front washer switch off
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Headlight Cleaner Control Relay)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← DATA LIST / ACTIVE TEST (from Aug 2013)Washer Signal Circuit (from Aug 2014) →