2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

  1. B239600
    Using moulding remover A, detach the 3 claws and remove the rear door inside handle bezel as shown in the illustration.


4. REMOVE ASSIST GRIP COVER LH

  1. B239602
    Using moulding remover A, detach the 8 claws and remove the assist grip cover.


5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B239604
    Remove the 3 screws.

  1. Using a clip remover, detach the 9 clips.

  1. B239606
    Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.

  1. Raise the rear door trim board sub-assembly to detach the 4 claws and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.

  1. B239612
    Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly as shown in the illustration.

  1. B239616E02
    Disconnect each connector.
    Text in Illustration 
    *A
    for 14 Speakers
    *B
    for 9 Speakers

  1. B241320
    Using a screwdriver, detach the claw and remove the clamp.


6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

  1. B239615
    Using a screwdriver, detach the 3 claws and remove the rear door inner glass weatherstrip from the rear door trim board sub-assembly as shown in the illustration.


7. REMOVE REAR SPEAKER SET

  1. B239136
    Disconnect the connector.

  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the rear speaker set.

    NOTICE:
    Do not touch the cone of the speaker.


8. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 14 Speakers)

  1. B239137
    Remove the 2 screws and No. 2 speaker.

    NOTICE:
    Do not touch the cone of the speaker.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →