2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E278018E10

INSPECTION PROCEDURE


1. CHECK COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM)

  1. E280963E10
    Check the output waveform.
    1. Remove the combination meter assembly with the connector(s) still connected.

    2. Connect an oscilloscope to terminal G6-32 (+S) and body ground.

    3. Turn the engine switch on (IG).

    4. Turn a wheel slowly.

    5. Check the signal waveform according to the condition(s) in the table below.

      Item
      Condition
      Measurement terminal
      G6-32 (+S) - Body ground
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Vehicle condition
      Wheel being rotated

      OK:
      The waveform is similar to that shown in the illustration.

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

      Text in Illustration 
      *a
      Component with harness connected
      (Combination Meter Assembly)



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the H63 stereo component amplifier assembly connector.

  1. Disconnect the G6 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H63-11 (SPD) - G6-32 (+S)
    Always
    Below 1 Ω
    H63-11 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (Aug 2013 – Jul 2014)Reverse Signal Circuit (Aug 2013 – Jul 2014) →