2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2000 Short to B+ in Seat Belt Motor RH Circuit

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The seat belt control ECU receives collision information from the driving support ECU and skid control ECU via CAN communication and tightens the seat belt by operating the motor inside the front seat outer belt RH.
When DTC B2000 is stored, DTCs B2016, B2026, B2027 and B2035 are not stored.
DTC Code
DTC Detection Condition
Trouble Area
B2000
During the initial check or with the ignition switch ON, the seat belt motor RH circuit has a power supply short (the voltage at terminals MOR+ and MOR- is 8.5 V or higher) for 1 second or more.
  1. Front seat outer belt assembly RH
  2. Harness or connector
  3. Seat belt control ECU

WIRING DIAGRAM

E200776E01

INSPECTION PROCEDURE

CAUTION:
The pretensioner is built into the front seat outer belt assembly RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may activate the pretensioner.


1. CHECK FRONT SEAT OUTER BELT ASSEMBLY RH CIRCUIT

  1. E178608E06
    Disconnect the G117 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G117-2 (MOR+) - Body ground
    Ignition switch ON
    Below 1 V
    G117-1 (MOR-) - Body ground

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Seat Belt Control ECU)



NG
Go to step 2
OK

REPLACE SEAT BELT CONTROL ECU (Click here)

2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT RH - SEAT BELT CONTROL ECU)

  1. E178609E05
    Disconnect the Q3 belt connector.

  1. Disconnect the G117 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Q3-1 (MOR+) - Body ground
    Ignition switch ON
    Below 1 V
    Q3-2 (MOR-) - Body ground

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Front Seat Outer Belt Assembly RH)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH (Click here)


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014)B2000 Short to B+ in Seat Belt Motor RH Circuit (from Aug 2014) →