2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

NOTICE:
  1. Do not twist the connectors of the driving support ECU when connecting them.
  2. Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

HINT:
  1. A bolt without a torque specification is shown in the standard bolt chart (Click here).
  2. Use the same procedure for RHD and LHD vehicles.
  3. The procedure listed below is for LHD vehicles.


1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

E198279
  1. Attach the claw to install the driving support ECU assembly.

    NOTICE:
    When a new ECU is installed, perform initialization (Click here).


2. INSTALL ECU INTEGRATION BOX RH
  1. Install the ECU integration box RH with the 2 nuts and bolt.

  1. Attach the clamp.

  1. Connect the connectors.


3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
  1. Attach the 2 claws to install the No. 2 air duct sub-assembly.

  1. Install the screw.


4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

B238219E01
  1. Connect each connector.

  1. Attach the 5 clips and claw to install the glove compartment door.

  1. Install the 2 bolts <C> and 2 screws <A> or <B>.

    Text in Illustration 
    *1
    Bolt
    *2
    Screw


5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

  1. Install the screw.

    B298555E01

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD


6. INSTALL INSTRUMENT PANEL ORNAMENT
  1. Attach the 5 clips to install the instrument panel ornament.


7. INSTALL INSTRUMENT SIDE PANEL RH
  1. Connect the connector.

  1. Attach the 5 clips, claw and 3 guides to install the instrument side panel.


8. INSTALL COWL SIDE TRIM BOARD RH
  1. Attach the clip and claw to install the cowl side trim board.

  1. Install the clip.


9. INSTALL DOOR SCUFF PLATE ASSEMBLY RH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →