INSTALLATION
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL ELECTRICAL KEY ANTENNA (for 5 Door) |
Install the antenna with the bolt.

- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Connect the connector.
| 2. INSTALL ELECTRICAL KEY ANTENNA (for 3 Door) |
Install the antenna with the bolt.

- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 3. INSTALL REAR BUMPER SIDE MOUNTING BRACKET LH (for 3 Door) |
Connect the connector.
Install the rear bumper side mounting bracket with the bolts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 4. INSTALL REAR BUMPER COVER (for 3 Door) |
w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 4 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
Connect the 2 connectors.
w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 2 connectors.
Attach the 10 claws to install the rear bumper cover.
Install the 7 bolts and 2 clips.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 5. INSTALL REAR QUARTER PANEL MUDGUARD LH (for 3 Door) |
Install the rear quarter panel mudguard with the 5 screws and 2 clips.
| 6. INSTALL REAR QUARTER PANEL MUDGUARD RH (for 3 Door) |
- HINT:
- Use the same procedure described for the LH side.
| 7. INSTALL REAR NO. 1 BUMPER PLATE (for 3 Door) |
Attach the 10 claws and 10 guides to install the No. 1 rear bumper plate.
| 8. INSTALL REAR BUMPER BAR PLATE (for 3 Door) |
Attach the 14 claws to install the rear bumper bar plate.
| 9. INSTALL BACK DOOR CHECK (for 3 Door) |
Bumper side:
Install the back door check with back door lower damper stay bracket with the 2 bolts labeled A.

- Torque:
- 30 N*m{ 306 kgf*cm , 22 ft.*lbf }
Install the bolt labeled B.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Attach the wire harness.
Back door side:
Attach the clip to install the back door check with back door lower damper stay bracket.

Install the 2 bolts.
- Torque:
- 30 N*m{ 306 kgf*cm , 22 ft.*lbf }
| 10. INSTALL JACK BOX HOLE COVER (for 3 Door) |
Attach the 2 claws to install the jack box hole cover.
