REMOVAL
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. REMOVE JACK BOX HOLE COVER (for 3 Door) |
![]() ![]() |
Using a screwdriver, detach the 2 claws and remove the jack box hole cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1
Protective Tape
| 2. REMOVE BACK DOOR CHECK (for 3 Door) |
- NOTICE:
- If the back door check is detached from a ball joint, do not reuse it as the connection with the ball joint will be loose, resulting in the back door check falling off.
- If the back door check is detached from a ball joint, it becomes non-reusable. Therefore, do not detach the back door check from a ball joint unless replacing it.
- If the back door check is detached from a ball joint, do not reuse it as the connection with the ball joint will be loose, resulting in the back door check falling off.
Remove the 2 bolts.

Using a clip remover, detach the clip and remove the back door check with back door lower damper stay bracket.
Detach the wire harness clamp.

Remove the 3 bolts and back door check with back door lower damper stay bracket.
| 3. REMOVE REAR BUMPER BAR PLATE (for 3 Door) |
Put protective tape around the rear bumper bar plate.
Detach the 14 claws and remove the rear bumper bar plate.


Text in Illustration *1
Protective Tape
-
-
| 4. REMOVE REAR NO. 1 BUMPER PLATE (for 3 Door) |
Put protective tape around the No. 1 rear bumper plate.
Detach the 10 claws and 10 guides and remove the No. 1 rear bumper plate.


Text in Illustration *1
Protective Tape
-
-
| 5. REMOVE REAR QUARTER PANEL MUDGUARD LH (for 3 Door) |
![]() ![]() |
Remove the 2 clips and 5 screws.
Remove the rear quarter panel mudguard.
| 6. REMOVE REAR QUARTER PANEL MUDGUARD RH (for 3 Door) |
- HINT:
- Use the same procedure described for the LH side.
| 7. REMOVE REAR BUMPER COVER (for 3 Door) |
Put protective tape around the rear bumper cover.
Remove the 2 clips and 7 bolts.
Detach the 10 claws.
w/ TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 4 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
Disconnect the 2 connectors.
w/o TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 2 connectors.
Remove the rear bumper cover.


Text in Illustration *1
Protective Tape
-
-
| 8. REMOVE REAR BUMPER SIDE MOUNTING BRACKET LH (for 3 Door) |
![]() ![]() |
w/ Entry and Start System:
Disconnect the connector.
Remove the bolt and rear bumper side moulding bracket.
| 9. REMOVE ELECTRICAL KEY ANTENNA (for 3 Door) |
Remove the bolt and antenna.

| 10. REMOVE ELECTRICAL KEY ANTENNA (for 5 Door) |
Disconnect the connector.

Remove the bolt and antenna.



