2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for 5 Door)

B216142E02
  1. Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 18 (LED)
      Battery negative (-) → 12 (GND)
      LED illuminates

      1. If the result is not as specified, replace the multiplex network master switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Multiplex Network Master Switch Assembly)


INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for 3 Door)

B216141E03
  1. Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 18 (LED)
      Battery negative (-) → 12 (GND)
      LED illuminates

      1. If the result is not as specified, replace the multiplex network master switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Multiplex Network Master Switch Assembly)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →