2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
  1. Install the multiplex network master switch assembly with the 3 screws .


2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

  1. B238605
    Install the front door inner glass weatherstrip.


3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B241244
    Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

  1. Connect 2 connectors.

  1. w/ Seat Position Memory System:

    1. Connect the connectors.

  1. B241251
    Attach the front door trim board sub-assembly by attaching the 4 claws of the front door inner glass weatherstrip as shown in the illustration.

  1. B238522
    Attach the 12 clips and front door trim board retainer to install the front door trim board sub-assembly.

  1. Install the 3 screws.


4. INSTALL ASSIST GRIP COVER LH

  1. B241252
    Attach the 8 claws to install the assist grip cover.


5. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

  1. B241259
    Attach the 3 claws to install the inside handle bezel.


6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
  1. Attach the 2 claws to install the front door lower frame bracket garnish.

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2014) →