INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
6 (UP) - 1 (GND)
Manual up operation
Below 1 Ω
7 (DOWN) - 1 (GND)
Manual down operation
Below 1 Ω
8 (AUTO) - 1 (GND)
Auto up/down operation
Below 1 Ω
- If the result is not as specified, replace the power window regulator switch assembly.
Check that the LED illuminates.
Apply battery voltage to the power window regulator switch and check that the LED illuminates.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → 4 (LED)
Battery negative (-) → 1 (GND)
LED illuminates
- If the result is not as specified, replace the power window regulator switch assembly.
Text in Illustration *1
LED
*a
Component without harness connected
(Power Window Regulator Switch Assembly)
