2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH

  1. B240614
    Detach the 2 clips and remove the front door lower frame bracket garnish LH.


2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL RH

  1. B238520
    Using a moulding remover, detach the 3 claws and remove the inside handle bezel as shown in the illustration.


3. REMOVE ASSIST GRIP COVER RH

  1. B238521
    Using moulding remover A, detach the 8 claws and remove the assist grip cover.


4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

  1. B238522
    Remove the 3 screws.

  1. Remove the 12 clips.

  1. B238523E01
    Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.
    Text in Illustration 
    *1
    Reference Boss

  1. Raise the front door trim board sub-assembly to detach the 4 claws and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip LH.

  1. B238524
    Disconnect the 2 connectors.

  1. w/ Seat Position Memory System:

    1. B240206
      Disconnect the connectors.

  1. B238525
    Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.


5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP RH

  1. B238526
    Using a screwdriver, detach the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.


6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY

B193241
  1. Detach the 2 claws and remove the power window regulator switch assembly.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →