2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

B218617E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (UP) - 1 (GND)
    Manual up operation
    Below 1 Ω
    7 (DOWN) - 1 (GND)
    Manual down operation
    Below 1 Ω
    8 (AUTO) - 1 (GND)
    Auto up/down operation
    Below 1 Ω

    1. If the result is not as specified, replace the rear power window regulator switch assembly.

  1. Check that the LED illuminates.

    1. Apply battery voltage to the regulator switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (LED)
      Battery negative (-) → 1 (GND)
      LED illuminates

      1. If the result is not as specified, replace the rear power window regulator switch assembly.
      Text in Illustration 
      *1
      LED
      *a
      Component without harness connected
      (Rear Power Window Regulator Switch Assembly)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →