2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

U0100 Lost Communication with ECM

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

These DTCs are stored when the clearance warning ECU cannot receive and recognize certain signals via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
U0100
A problem with the engine information signal from the ECM
CAN communication system
U0101
A problem with the shift position information signal from the power management control ECU
CAN communication system
U0142
A problem with the vehicle information signal from the main body ECU (multiplex network body ECU)
CAN communication system
U0155
A problem with the vehicle speed information signal from the combination meter assembly
CAN communication system

HINT:
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harness of each ECU.


INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC (CAN communication system DTC) is output (for LHD with Entry and Start System)
    A
    DTC (CAN communication system DTC) is output (for LHD without Entry and Start System)
    B
    DTC (CAN communication system DTC) is output (for RHD with Entry and Start System)
    C
    DTC (CAN communication system DTC) is output (for RHD without Entry and Start System)
    D
    No DTC is output
    E



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)


← U0100 Lost Communication with ECM (+ U0101, U0142, U0155) (Aug 2013 – Jul 2014)Reverse Signal Circuit (Aug 2013 – Jul 2014) →