2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2768 Tilt Sensor Internal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when one of the following occurs: 1) a yaw rate sensor assembly power supply malfunction; 2) a yaw rate sensor assembly open malfunction; or 3) an EEPROM malfunction.
DTC Code
DTC Detection Condition
Trouble Area
B2768
One of the following conditions is met:
  1. A yaw rate sensor assembly power supply malfunction.
  2. A yaw rate sensor assembly open malfunction.
  3. An EEPROM malfunction.
  1. Yaw rate sensor assembly
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM

B240858E01

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the yaw rate sensor assembly, perform zero point calibration.
    Vehicle stability control system (for Hydraulic Brake Booster) (Click here).
    Vehicle stability control system (for Vacuum Brake Booster) (Click here).


1. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR - BATTERY AND BODY GROUND)

  1. B243074E01
    Disconnect the G52 sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G52-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G52-6 (+B) - Body ground
    Always
    11 to 14 V
    G52-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Yaw Rate Sensor Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON, and then off.

  1. Set the theft deterrent system to the armed state (Click here).

  1. Check that the security indicator light changes from illuminated to flashing.

  1. Set the theft deterrent system to the disarmed state (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2768 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. REPLACE YAW RATE SENSOR ASSEMBLY
  1. Temporarily replace the yaw rate sensor assembly with a new or normally functioning one (Click here).


NEXT


4. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON, and then off.

  1. Set the theft deterrent system to the armed state (Click here).

  1. Check that the security indicator light changes from illuminated to flashing.

  1. Set the theft deterrent system to the disarmed state (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2768 is not output.



NG
REPLACE MAIN BODY ECU (Click here)
OK

END (YAW RATE SENSOR ASSEMBLY IS DEFECTIVE)


← B2768 Tilt Sensor Internal Circuit Malfunction (Aug 2013 – Jul 2014)B2769 Tilt Sensor Signal Circuit Malfunction (+ B276A) (Aug 2013 – Jul 2014) →