B2769 Tilt Sensor Signal Circuit Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Also covers:
- B276A Short to GND in Tilt Sensor Signal Circuit
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The yaw rate sensor assembly conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).If a malfunction is detected in the CSIF-GCS line, the main body ECU stores DTC B2769.
DTC B276A is stored when terminal CSIF of the yaw rate sensor assembly has not received a signal for 5 seconds or more.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2769 |
After a normal/trouble signal is output from the yaw rate sensor assembly as a result of self-diagnosis, following malfunctions are detected:
|
|
| B276A |
Terminal CSIF of the yaw rate sensor assembly has not received a signal for 5 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate sensor assembly, perform zero point calibration.
- Vehicle stability control system (for Hydraulic Brake Booster) (Click here).
- Vehicle stability control system (for Vacuum Brake Booster) (Click here).
- Vehicle stability control system (for Hydraulic Brake Booster) (Click here).
| 1. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR - MAIN BODY ECU) |
Disconnect the G52 sensor connector.
Disconnect the G63 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G52-5 (CSIF) - G63-6 (GCS)
Always
Below 1 Ω
G52-5 (CSIF) or G63-6 (GCS) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. REPLACE YAW RATE SENSOR ASSEMBLY |
Temporarily replace the yaw rate sensor assembly with a new or normally functioning one (Click here).
| NEXT | |
| 3. CHECK FOR DTC |
Clear the DTCs (Click here).
Turn the ignition switch to ON, and then off.
Set the theft deterrent system to the armed state (Click here).
Check that the security indicator light changes from illuminated to flashing.
Set the theft deterrent system to the disarmed state (Click here).
Check for DTCs (Click here).
- OK:
- DTC B2769 or B276A is not output.
|
|
||||
| OK | ||
| ||
