B2789 No Response from ID BOX
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is output when LIN communication between the certification ECU and ID code box stops for 10 seconds or more.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2789 |
No communication between the certification ECU and ID code box for 10 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
- Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
- When using the intelligent tester with the ignition switch off to troubleshoot:
- HINT:
- When communication between the ID code box and certification ECU stops, DTC B2785 is also stored.
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Check for DTCs (Click here).
- OK:
- DTC B2789 is not output.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX) |
Disconnect the G38 certification ECU connector.
Disconnect the G37 ID code box connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G38-29 (LIN) - G37-3 (LIN1)
Always
Below 1 Ω
G38-29 (LIN) or G37-3 (LIN1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND) |
Disconnect the G37 ID code box connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G37-8 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
G37-1 (+B) - Body ground
Always
11 to 14 V
| *a |
Front view of wire harness connector (to ID Code Box) |
|
|
||||
| OK | |
| 5. REPLACE ID CODE BOX |
Temporarily replace the ID code box with a new one.
| NEXT | |
| 6. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7. CHECK FOR DTC |
Check for DTCs (Click here).
- OK:
- DTC B2789 is not output.
|
|
||||
| OK | ||
| ||
