2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

Air Conditioning Control Panel does not Operate

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When a switch of the integration control and panel assembly or air conditioning control assembly* is operated, the integration control and panel assembly or air conditioning control assembly* uses LIN communication to communicate with the air conditioning amplifier. If a switch of the integration control and panel assembly or air conditioning control assembly* does not operate properly, a problem with the LIN communication between the integration control and panel assembly or air conditioning control assembly* and air conditioning amplifier may be causing the malfunction.
  1. *: w/ Rear Air Conditioning System

WIRING DIAGRAM

C212395E11

INSPECTION PROCEDURE


1. CHECK SWITCH OPERATION
  1. Check the switch operation.

    Result 
    Result
    Proceed to
    Integration control and panel assembly does not operate
    A
    Air conditioning panel assembly does not operate
    B



B
Go to step 3
A


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - INTEGRATION CONTROL AND PANEL)
  1. Disconnect the G25 air conditioning amplifier assembly connector.

  1. Disconnect the G23 integration control and panel assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G25-37 (LIN1) - G23-3 (LIN1)
    Always
    Below 1 Ω
    G25-37 (LIN1) or G23-3 (LIN1) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for Automatic Air Conditioning System)
    A
    OK (for Manual Air Conditioning System)
    B
    NG
    C



B
Go to AIR CONDITIONING SYSTEM (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

Go to AIR CONDITIONING SYSTEM (Click here)

3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - AIR CONDITIONING CONTROL)
  1. Disconnect the G24 air conditioning amplifier assembly connector.

  1. Disconnect the T7 air conditioning control assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G24-13 (RLIN) - T7-6 (RLIN)
    Always
    Below 1 Ω
    G24-13 (RLIN) or T7-6 (RLIN) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for Automatic Air Conditioning System)
    A
    OK (for Manual Air Conditioning System)
    B
    NG
    C



B
Go to AIR CONDITIONING SYSTEM (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

Go to AIR CONDITIONING SYSTEM (Click here)


← Rain Sensor LIN Communication Malfunction (from Aug 2014)Air Conditioning Control Panel does not Operate (from Aug 2014) →