Rain Sensor LIN Communication Malfunction
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
When the auto wiper system is operated, the windshield wiper switch assembly uses LIN communication to communicate with the rain sensor. If the auto wiper system does not operate properly, a problem with the LIN communication between the windshield wiper switch assembly and rain sensor may be causing the malfunction.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY - RAIN SENSOR) |
Disconnect the G120 windshield wiper switch assembly connector.
Disconnect the W6 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G120-5 (MPX1) - W6-3 (MPX)
Always
Below 1 Ω
G120-5 (MPX1) or W6-3 (MPX) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
