The Active Control Engine Mount (ACM) system decreases engine vibration at low engine speed using the VSV for engine mount. The VSV is controlled by a pulse signal transmitted to the VSV from the ECM. The frequency of this pulse signal is matched to the engine speed to decrease engine vibration.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Warm up the engine.
Connect the intelligent tester to the DLC3.
Move the shift lever to N or P.
Enter the following menus: Powertrain / Engine / Active Test / Control the ACM Inhibit.
Hold the top part of the steering wheel, and turn the Active Test from OFF to ON. Check the engine vibration.