ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT VACUUM SWITCHING VALVE (for Engine Mounting) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
37 to 44 Ω
1 - Body ground
2 - Body ground
20°C (68°F)
1 MΩ or higher
If the result is not as specified, replace the vacuum switching valve.Text in Illustration *a
Component without harness connected
(Vacuum Switching Valve (for Engine Mounting))
Check operation of the vacuum switching valve.

When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.
Text in Illustration *1
Port E
*2
Port F
*3
Vacuum
*4
Air
*5
Filter
Apply battery voltage across terminals 1 and 2.

Text in Illustration *1
Port E
*2
Port F
*3
Air
Check that air flows from port E to port F.
If the result is not as specified, replace the vacuum switching valve.
