2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT HOOD MOULDING ASSEMBLY

B239518
  1. Remove the 7 nuts and front hood moulding.


2. REMOVE HOOD TO RADIATOR SUPPORT SEAL

  1. B238461
    Using a clip remover, detach the 7 clips and remove the hood to radiator support seal.


3. REMOVE HOOD INSULATOR

  1. B238462
    Using a clip remover, remove the 11 clips.

  1. Detach the 2 claws and remove the hood insulator.


4. REMOVE WASHER NOZZLE SUB-ASSEMBLY

  1. E197819E01
    Using a screwdriver, detach the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Be careful not to damage the windshield.

  1. E197820
    Disconnect the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.


5. DISCONNECT WASHER HOSE ASSEMBLY

  1. B238463
    Detach the 4 clamps and disconnect the washer hose assembly.


6. REMOVE HOOD SUPPORT ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while performing work.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the hood support.

  1. B238468E01
    Using a screwdriver, remove the 2 stop rings as shown in the illustration, and then remove the hood support.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Remove the hood support assembly while supporting the hood panel with one hand.


7. REMOVE HOOD SUPPORT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.

← ON-VEHICLE INSPECTION (from Aug 2013)ADJUSTMENT (from Aug 2013) →