Hazard Warning Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The turn signal flasher receives a hazard warning signal switch information signal and illuminates the turn signal lights.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
![]() ![]() ![]() ![]() |
w/ Display
Remove the hazard warning signal switch (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 4
Hazard warning signal switch on
Below 1 Ω
Hazard warning signal switch off
10 kΩ or higher
w/o Display
Remove the hazard warning signal switch (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
16 - 3
Hazard warning signal switch on
Below 1 Ω
Hazard warning signal switch off
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - TURN SIGNAL FLASHER ASSEMBLY AND BODY GROUND) |
- *1: w/ Navigation System
- *2: w/o Navigation System
Disconnect the y1*1 or G160*2 hazard warning signal switch connector.
Disconnect the G8 turn signal flasher connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
- w/ Navigation System :
Tester Connection
Condition
Specified Condition
y1- 4 - 8 (HAZ)
Always
Below 1 Ω
y1-1 - Body ground
Always
Below 1 Ω
y1-4 - Body ground
Always
10 kΩ or higher
- w/o Navigation System:
Tester Connection
Condition
Specified Condition
G160-3 - 8 (HAZ)
Always
Below 1 Ω
G160-16 - Body ground
Always
Below 1 Ω
G160-3 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||


