2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Hazard Warning Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The turn signal flasher receives a hazard warning signal switch information signal and illuminates the turn signal lights.

WIRING DIAGRAM

E284769E01

INSPECTION PROCEDURE


1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
E179050
E284773
  1. w/ Display

    1. Remove the hazard warning signal switch (Click here).

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 4
      Hazard warning signal switch on
      Below 1 Ω
      Hazard warning signal switch off
      10 kΩ or higher

  1. w/o Display

    1. Remove the hazard warning signal switch (Click here).

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      16 - 3
      Hazard warning signal switch on
      Below 1 Ω
      Hazard warning signal switch off
      10 kΩ or higher



NG
REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - TURN SIGNAL FLASHER ASSEMBLY AND BODY GROUND)
  1. *1: w/ Navigation System
  2. *2: w/o Navigation System
  1. Disconnect the y1*1 or G160*2 hazard warning signal switch connector.

  1. Disconnect the G8 turn signal flasher connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    w/ Navigation System :
    Tester Connection
    Condition
    Specified Condition
    y1- 4 - 8 (HAZ)
    Always
    Below 1 Ω
    y1-1 - Body ground
    Always
    Below 1 Ω
    y1-4 - Body ground
    Always
    10 kΩ or higher
    w/o Navigation System:
    Tester Connection
    Condition
    Specified Condition
    G160-3 - 8 (HAZ)
    Always
    Below 1 Ω
    G160-16 - Body ground
    Always
    Below 1 Ω
    G160-3 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Rear Fog Light Circuit (from Aug 2014)Hazard Warning Switch Circuit (from Aug 2014) →