Indicator Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The warning indicator lights are installed in the clearance warning indicator assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING INDICATOR - BATTERY) |
 |
- Disconnect the G160 clearance warning indicator assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
G160-9 (BD) - Body ground
|
Ignition switch ON
|
11 to 14 V
|
Text in Illustration
*a
|
Front view of wire harness connector (to Clearance Warning Indicator Assembly)
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING INDICATOR) |
 |
Disconnect the I1 clearance warning ECU connector.
Disconnect the G160 clearance warning indicator light assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
I1-15 (L1) - G160-5 (RR)
|
Always
|
Below 1 Ω
|
I1-17 (L3) - G160-14 (RL)
|
Always
|
Below 1 Ω
|
I1-19 (L5) - G160-15 (BK)
|
Always
|
Below 1 Ω
|
I1-20 (L6) - G160-1 (OP)
|
Always
|
Below 1 Ω
|
I1-15 (L1) - Body ground
|
Always
|
10 kΩ or higher
|
I1-17 (L3) - Body ground
|
Always
|
10 kΩ or higher
|
I1-19 (L5) - Body ground
|
Always
|
10 kΩ or higher
|
I1-20 (L6) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|