2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Clearance Warning ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit is the power source circuit used to operate the clearance warning ECU.

WIRING DIAGRAM

E172196E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY AND BODY GROUND)

  1. B155759E01
    Disconnect the I1 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I1-10 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    I1-10 (IG) - Body ground
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I1-21 (E) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Clearance Warning ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning ECU Power Source Circuit (Aug 2013 – Jul 2014)Indicator Circuit (Aug 2013 – Jul 2014) →