2013-2015 Land Cruiser Prado · Service Manual Drivetrain

TERMINALS OF ECU

System information · Vehicles built from Aug 2013


CHECK 4 WHEEL DRIVE CONTROL ECU
C159461E11
  1. Measure the voltage and resistance according to the value(s) in the table below.

    for 1GR-FE, 1KD-FTV: 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G53-1 (HL1) - G54-4 (GND)
    GR - W-B
    High-low transfer shift actuator limit switch
    Ignition switch ON
    Transfer position switch H4
    10.5 to 14 V
    Ignition switch ON
    Transfer position switch L4
    Below 1.5 V
    G53-2 (HL2) - G54-4 (GND)
    LG - W-B
    High-low transfer shift actuator limit switch
    Ignition switch ON
    Transfer position switch H4
    Below 1.5 V
    Ignition switch ON
    Transfer position switch L4
    10.5 to 14 V
    G53-7 (TL2) - G54-4 (GND)
    V - W-B
    Multi mode transfer shift actuator limit switch
    Ignition switch ON
    Center differential lock switch Lock
    Below 1.5 V
    Ignition switch ON
    Center differential lock switch Free
    10.5 to 14 V
    G53-8 (TL3) - G54-4 (GND)
    G - W-B
    Multi mode transfer shift actuator limit switch
    Ignition switch ON
    Center differential lock switch Lock
    10.5 to 14 V
    Ignition switch ON
    Center differential lock switch Free
    Below 1.5 V
    G53-13 (LO) - G54-4 (GND)
    GR - W-B
    Transfer position switch
    Ignition switch ON
    Transfer position switch H4
    10.5 to 14 V
    Ignition switch ON
    Transfer position switch L4
    Below 1.5 V
    G53-14 (P1) - G54-4 (GND)
    W - W-B
    Multi mode transfer shift actuator
    Center differential lock position detection switch
    Ignition switch ON
    Center differential lock switch Free
    9.5 to 14 V
    Ignition switch ON
    Center differential lock switch Lock
    Below 1.5 V
    G53-16 (DL) - G54-4 (GND)
    W - W-B
    Center differential lock switch
    Ignition switch ON
    Center differential lock switch ON
    Below 1.5 V
    Ignition switch ON
    Center differential lock switch OFF
    9.5 to 14 V
    G53-17 (MTN)*1 - G54-4 (GND)
    B - W-B
    Clutch start switch
    Ignition switch ON
    Clutch start switch ON
    Below 1.5 V
    Ignition switch ON
    Clutch start switch OFF
    9.5 to 14 V
    G53-19 (CANH) - G54-4 (GND)
    G - W-B
    CAN communication line
    Ignition switch ON
    Pulse generation (see waveform 1)
    G53-20 (CANL) - G54-4 (GND)
    W - W-B
    CAN communication line
    Ignition switch ON
    Pulse generation (see waveform 2)
    G53-21 (L4) - G54-4 (GND)
    R - W-B
    Transfer L4 signal
    Ignition switch ON
    Transfer position switch H4
    10 to 14 V
    Ignition switch ON
    Transfer position switch L4
    Below 1.5 V
    G54-2 (HM1) - G54-4 (GND)
    B - W-B
    High-low transfer shift actuator motor
    Ignition switch ON
    Transfer position switch H4 → L4 (During operation of high-low transfer shift actuator motor from HIGH to LOW)
    10 to 14 V
    Ignition switch ON
    Transfer position switch H4 → L4 (High-low transfer shift actuator motor stopped)
    Below 1.5 V
    G54-3 (IG) - G54-4 (GND)
    R - W-B
    IG power
    Ignition switch ON
    11 to 14 V
    G54-4 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    G54-6 (HM2) - G54-4 (GND)
    W - W-B
    High-low transfer shift actuator motor
    Ignition switch ON
    Transfer position switch L4 → H4 (During operation of high-low transfer shift actuator motor from LOW to HIGH)
    10 to 14 V
    Ignition switch ON
    Transfer position switch L4 → H4 (High-low transfer shift actuator motor stopped)
    Below 1.5 V
    G54-7 (TM2) - G54-4 (GND)
    V - W-B
    Multi mode transfer shift actuator motor
    Ignition switch ON
    Center differential lock switch LOCK → FREE (During operation of multi mode transfer shift actuator motor from LOCK to FREE)
    10 to 14 V
    Ignition switch ON
    Center differential lock switch LOCK → FREE (Multi mode transfer shift actuator motor stopped)
    Below 1.5 V
    G54-8 (TM1) - G54-4 (GND)
    P - W-B
    Multi mode transfer shift actuator motor
    Ignition switch ON
    Center differential lock switch FREE → LOCK (During operation of multi mode transfer shift actuator motor from FREE to LOCK)
    10 to 14 V
    Ignition switch ON
    Center differential lock switch FREE → LOCK (Multi mode transfer shift actuator motor stopped)
    Below 1.5 V
    *1: for Manual Transmission
    for 2TR-FE, 5L-E: 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G53-1 (HL1) - G54-4 (GND)
    GR - W-B
    High-low transfer shift actuator limit switch
    Ignition switch ON
    Transfer position switch H4F or H4L
    10.5 to 14 V
    Ignition switch ON
    Transfer position switch L4L
    Below 1.5 V
    G53-2 (HL2) - G54-4 (GND)
    LG - W-B
    High-low transfer shift actuator limit switch
    Ignition switch ON
    Transfer position switch H4F or H4L
    Below 1.5 V
    Ignition switch ON
    Transfer position switch L4L
    10.5 to 14 V
    G53-6 (TL1) - G54-4 (GND)
    W-B - W-B
    Transfer operating switch mode selection signal
    Always
    Below 1 Ω
    G53-7 (TL2) - G54-4 (GND)
    V - W-B
    Multi mode transfer shift actuator limit switch
    Ignition switch ON
    Transfer position switch H4L or L4L
    Below 1.5 V
    Ignition switch ON
    Transfer position switch H4F
    10.5 to 14 V
    G53-8 (TL3) - G54-4 (GND)
    G - W-B
    Multi mode transfer shift actuator limit switch
    Ignition switch ON
    Transfer position switch H4L or L4L
    10.5 to 14 V
    Ignition switch ON
    Transfer position switch H4F
    Below 1.5 V
    G53-11 (2-4) - G54-4 (GND)
    R - W-B
    Transfer position switch
    Ignition switch ON
    Transfer position switch H4F or H4L
    Below 1.5 V
    Ignition switch ON
    Transfer position switch L4L
    10.5 to 14 V
    G53-13 (LO) - G54-4 (GND)
    GR - W-B
    Transfer position switch
    Ignition switch ON
    Transfer position switch H4F
    10.5 to 14 V
    Ignition switch ON
    Transfer position switch H4L or L4L
    Below 1.5 V
    G53-14 (P1) - G54-4 (GND)
    W - W-B
    Multi mode transfer shift actuator
    Center differential lock position detection switch
    Ignition switch ON
    Transfer position switch H4F
    9.5 to 14 V
    Ignition switch ON
    Transfer position switch H4L or L4L
    Below 1.5 V
    G53-17 (MTN)*1 - G54-4 (GND)
    B - W-B
    Clutch start switch
    Ignition switch ON
    Clutch start switch ON
    Below 1.5 V
    Ignition switch ON
    Clutch start switch OFF
    9.5 to 14 V
    G53-19 (CANH) - G54-4 (GND)
    G - W-B
    CAN communication line
    Ignition switch ON
    Pulse generation (see waveform 1)
    G53-20 (CANL) - G54-4 (GND)
    W - W-B
    CAN communication line
    Ignition switch ON
    Pulse generation (see waveform 2)
    G53-21 (L4) - G54-4 (GND)
    R - W-B
    Transfer L4 signal
    Ignition switch ON
    Transfer position switch H4F or H4L
    10 to 14 V
    Ignition switch ON
    Transfer position switch L4L
    Below 1.5 V
    G54-2 (HM1) - G54-4 (GND)
    B - W-B
    High-low transfer shift actuator motor
    Ignition switch ON
    Transfer position switch H4L → L4L (During operation of high-low transfer shift actuator motor from HIGH to LOW)
    10 to 14 V
    Ignition switch ON
    Transfer position switch H4L → L4L (High-low transfer shift actuator motor stopped)
    Below 1.5 V
    G54-3 (IG) - G54-4 (GND)
    R - W-B
    IG power
    Ignition switch ON
    11 to 14 V
    G54-4 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    G54-6 (HM2) - G54-4 (GND)
    W - W-B
    High-low transfer shift actuator motor
    Ignition switch ON
    Transfer position switch L4L → H4L (During operation of high-low transfer shift actuator motor from LOW to HIGH)
    10 to 14 V
    Ignition switch ON
    Transfer position switch L4L → H4L (High-low transfer shift actuator motor stopped)
    Below 1.5 V
    G54-7 (TM2) - G54-4 (GND)
    V - W-B
    Multi mode transfer shift actuator motor
    Ignition switch ON
    Transfer position switch H4L → H4F (During operation of multi mode transfer shift actuator motor from LOCK to FREE)
    10 to 14 V
    Ignition switch ON
    Transfer position switch H4L → H4F (Multi mode transfer shift actuator motor stopped)
    Below 1.5 V
    G54-8 (TM1) - G54-4 (GND)
    P - W-B
    Multi mode transfer shift actuator motor
    Ignition switch ON
    Transfer position switch H4F → H4L (During operation of multi mode transfer shift actuator motor from FREE to LOCK)
    10 to 14 V
    Ignition switch ON
    Transfer position switch H4F → H4L (Multi mode transfer shift actuator motor stopped)
    Below 1.5 V
    *1: for Manual Transmission

  2. A086154E52
    Using an oscilloscope, check waveform 1.
    Waveform 1 (Reference) 
    Item
    Content
    Terminal No. (Symbol)
    G53-19 (CANH) - G54-4 (GND)
    Tool setting
    1 V/DIV., 10 μsec./DIV.
    Condition
    Engine stopped and ignition switch ON
    Text in Illustration 
    *1
    Waveform 1

    HINT:
    The waveform varies depending on the CAN communication signal.

  3. A086155E01
    Using an oscilloscope, check waveform 2.
    Waveform 2 (Reference) 
    Item
    Content
    Terminal No. (Symbol)
    G53-20 (CANL) - G54-4 (GND)
    Tool setting
    1 V/DIV., 10 μsec./DIV.
    Condition
    Engine stopped and ignition switch ON
    Text in Illustration 
    *1
    Waveform 2

    HINT:
    The waveform varies depending on the CAN communication signal.

← PROBLEM SYMPTOMS TABLE (from Aug 2014)INSPECTION (Aug 2013 – Jul 2014) →