2013-2015 Land Cruiser Prado · Service Manual Drivetrain

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Transfer System 
Symptom
Suspected Area
See page
Noise
Oil (Level low)
Click here
Oil (Wrong)
Click here
Transfer faulty
Click here
Oil leakage
Oil (Level too high)
Click here
Gasket (Damaged)
Click here
Oil seal (Worn or damaged)
Click here
O-ring (Worn or damaged)
Click here
Switch from HIGH to LOW is impossible
Harness or connector
Click here
Transfer shift actuator assembly
Click here
CAN communication system (for LHD with Entry and Start System)
Click here
CAN communication system (for LHD without Entry and Start System)
Click here
CAN communication system (for RHD with Entry and Start System)
Click here
CAN communication system (for RHD without Entry and Start System)
Click here
Transfer position switch (w/o Combination Switch)
Click here
Transfer position switch (w/ Combination Switch)
Click here
4 wheel drive control ECU
Click here
Transfer faulty
Click here
Switch from LOW to HIGH is impossible
Harness or connector
Click here
Transfer shift actuator assembly
Click here
CAN communication system (for LHD with Entry and Start System)
Click here
CAN communication system (for LHD without Entry and Start System)
Click here
CAN communication system (for RHD with Entry and Start System)
Click here
CAN communication system (for RHD without Entry and Start System)
Click here
Transfer position switch (w/o Combination Switch)
Click here
Transfer position switch (w/ Combination Switch)
Click here
4 wheel drive control ECU
Click here
Transfer faulty
Click here
Switch from FREE to LOCK is impossible
Harness or connector
Click here
Transfer shift actuator assembly
Click here
CAN communication system (for LHD with Entry and Start System)
Click here
CAN communication system (for LHD without Entry and Start System)
Click here
CAN communication system (for RHD with Entry and Start System)
Click here
CAN communication system (for RHD without Entry and Start System)
Click here
Transfer position switch (for 2TR-FE, 5L-E)
Click here
Center differential lock switch (w/o Combination Switch)
Click here
Center differential lock switch (w/ Combination Switch)
Click here
4 wheel drive control ECU
Click here
Transfer faulty
Click here
Switch from LOCK to FREE is impossible
Harness or connector
Click here
Transfer shift actuator assembly
Click here
CAN communication system (for LHD with Entry and Start System)
Click here
CAN communication system (for LHD without Entry and Start System)
Click here
CAN communication system (for RHD with Entry and Start System)
Click here
CAN communication system (for RHD without Entry and Start System)
Click here
Transfer position switch (for 2TR-FE, 5L-E)
Click here
Center differential lock switch (w/o Combination Switch)
Click here
Center differential lock switch (w/ Combination Switch)
Click here
4 wheel drive control ECU
Click here
Transfer faulty
Click here
4LO indicator light does not come on
Harness or connector
Click here
Combination meter
Click here
CAN communication system (for LHD with Entry and Start System)
Click here
CAN communication system (for LHD without Entry and Start System)
Click here
CAN communication system (for RHD with Entry and Start System)
Click here
CAN communication system (for RHD without Entry and Start System)
Click here
4 wheel drive control ECU
Click here
Transfer position switch (w/o Combination Switch)
Click here
Transfer position switch (w/ Combination Switch)
Click here
Transfer shift actuator assembly
Click here
4LO indicator light remains on
4 wheel drive control ECU
Click here
Transfer position switch (w/o Combination Switch)
Click here
Transfer position switch (w/ Combination Switch)
Click here
Combination meter
Click here
Center differential lock indicator light does not come on
Harness or connector
Click here
Combination meter
Click here
CAN communication system (for LHD with Entry and Start System)
Click here
CAN communication system (for LHD without Entry and Start System)
Click here
CAN communication system (for RHD with Entry and Start System)
Click here
CAN communication system (for RHD without Entry and Start System)
Click here
4 wheel drive control ECU
Click here
Transfer position switch (for 2TR-FE, 5L-E)
Click here
Center differential lock switch (w/o Combination Switch)
Click here
Center differential lock switch (w/ Combination Switch)
Click here
Transfer shift actuator assembly
Click here
Center differential lock indicator light remains on (Blinking)
4 wheel drive control ECU
Click here
Transfer position switch (for 2TR-FE, 5L-E)
Click here
Center differential lock switch (w/o Combination Switch)
Click here
Center differential lock switch (w/ Combination Switch)
Click here
Combination meter
Click here
← PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014)TERMINALS OF ECU (from Aug 2013) →