2013-2015 Land Cruiser Prado · Service Manual Drivetrain

Pattern Select Switch 2nd Start Mode Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When 2nd start mode is selected with the pattern select (2ND) switch, the ECM controls the solenoid valves and the transmission starts from 2nd gear.
The 2nd mode is the system that operates the throttle motor to control engine output to reduce skidding of the driving wheels, and guarantee takeoff acceleration, driving straightness and turning stability.
When the shift lever is in D, the transmission automatically shifts up through 2nd to 5th as usual.

HINT:
  1. The pattern select (2ND) switch is a momentary-type switch.
  2. In order to cancel 2nd mode, push the pattern select (2ND) switch again or turn the ignition switch off.


WIRING DIAGRAM

C214971E05

INSPECTION PROCEDURE


1. INSPECT PATTERN SELECT (2ND) SWITCH ASSEMBLY

  1. C199167E03
    Remove the pattern select (2ND) switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (E) - 4 (2ND)
    Pattern select (2ND) switch pushed
    Below 1 Ω
    1 (E) - 4 (2ND)
    Pattern select (2ND) switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Pattern Select (2ND) Switch Assembly)



NG
REPLACE PATTERN SELECT (2ND) SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (PATTERN SELECT (2ND) SWITCH - BODY GROUND)

  1. C200877E12
    Disconnect the G159 pattern select (2ND) switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G159-1 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (Pattern Select (2ND) Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (PATTERN SELECT (2ND) SWITCH - ECM)

  1. C214333E09
    Disconnect the G55 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    G55-21 (SNWI) - Body ground
    Pattern select (2ND) switch pushed
    Below 1 Ω
    G55-21 (SNWI) - Body ground
    Pattern select (2ND) switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Pattern Select Switch 2nd Start Mode Circuit (Aug 2013 – Jul 2014)L4 Position Switch Circuit (Aug 2013 – Jul 2014) →