2013-2015 Land Cruiser Prado · Service Manual Drivetrain

L4 Position Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The four wheel drive control ECU judges whether the transfer is in the L4 position based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM.
The four wheel drive control ECU then inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator.

WIRING DIAGRAM

Refer to DTC P2772 (Click here).

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)

  1. C209926E10
    Disconnect the G53 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G53-21 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Four Wheel Drive Control ECU)



NG
Go to step 2
OK

GO TO TRANSFER SYSTEM (Click here)

2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)

  1. C214333E05
    Disconnect the G55 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G55-16 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← Pattern Select Switch 2nd Start Mode Circuit (from Aug 2014)L4 Position Switch Circuit (from Aug 2014) →