C1419 Acceleration Sensor Internal Circuit
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU receives signals from the acceleration sensor via the CAN communication system.The acceleration sensor detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the acceleration sensor and the CAN communication system, DTC U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
This DTC is also stored when calibration is not completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1419 |
A data malfunction signal is received from the acceleration sensor. |
Acceleration sensor |
WIRING DIAGRAM
Refer to DTCs C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the acceleration sensor, perform calibration (Click here).
- HINT:
- When DTC U0124 is output together with DTC C1419, inspect and repair the trouble areas indicated by DTC U0124 first (Click here).
| 1. REPLACE ACCELERATION SENSOR |
Replace the acceleration sensor (Click here).
| NEXT | ||
| ||
