REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 2. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY |
for Automatic Transmission:
(Click here)
for Manual Transmission:
(Click here)
w/ Refrigerated Cool Box:
(Click here)
for Bench Seat Type:
(Click here)
| 3. REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type) |
| 4. REMOVE CENTER FLOOR CARPET ASSEMBLY (for Bench Seat Type) |
Remove the 4 bolts and center floor carpet assembly.

| 5. REMOVE YAW RATE AND ACCELERATION SENSOR |
Remove the 2 bolts and yaw rate and acceleration sensor.


Text in Illustration *A
for Automatic Transmission
*B
for Manual Transmission
Disconnect the connector.
for Automatic Transmission:
Detach the clamp from the sensor bracket.
