2013-2015 Land Cruiser Prado · Service Manual Brake

C1419 Acceleration Sensor Internal Circuit

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
These DTCs are also stored when calibration is not completed.
DTC Code
DTC Detection Condition
Trouble Area
C1419
A data malfunction signal is received from the acceleration sensor.
Yaw rate and acceleration sensor
C1435
A data malfunction signal is received from the yaw rate sensor.
Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform calibration (Click here).

HINT:
When DTC U0123, U0124 and/or U0126 is output together with DTC C1419 and/or C1435, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (Click here).


1. REPLACE YAW RATE AND ACCELERATION SENSOR
  1. Replace the yaw rate and acceleration sensor (Click here).

    NOTICE:
    Check the yaw rate and acceleration sensor signal after replacement (Click here).


NEXT

END


← C1419 Acceleration Sensor Internal Circuit (+ C1435) (Aug 2013 – Jul 2014)C1420 Acceleration Sensor Malfunction (Aug 2013 – Jul 2014) →