2013-2015 Land Cruiser Prado · Service Manual Brake

C1420 Acceleration Sensor Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Refer to DTC C1419 and C1435 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1420
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
  1. Sensor installation
  2. Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform calibration (Click here).

HINT:
When DTC U0123, U0124 and/or U0126 is output together with DTC C1420, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (Click here).


1. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and acceleration sensor is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY (Click here)
OK


2. REPLACE YAW RATE AND ACCELERATION SENSOR
  1. Replace the yaw rate and acceleration sensor (Click here).

    NOTICE:
    Check the yaw rate and acceleration sensor signal after replacement (Click here).


NEXT

END


← C1419 Acceleration Sensor Internal Circuit (+ C1435) (from Aug 2014)C1420 Acceleration Sensor Malfunction (from Aug 2014) →