2013-2015 Land Cruiser Prado · Service Manual Brake

C1417 High Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the actuator assembly) stores this DTC and the fail-safe function prohibits brake control system operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit, such as the battery or generator circuit, etc.
The DTC is cleared when the IG1 terminal voltage returns to normal.
DTC Code
DTC Detection Condition
Trouble Area
C1417
The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.
  1. ECU-IG NO. 1 fuse
  2. Battery
  3. Charging system
  4. Power source circuit
  5. Internal power supply circuit of the skid control ECU

WIRING DIAGRAM

Refer to DTC C1241 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the brake actuator assembly, perform calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK TERMINAL VOLTAGE (IG1)
  1. Disconnect the A6 skid control ECU connector.

  1. C199357E08
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A6-34 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← C1415 Rear Speed Sensor RH Output Malfunction (+ C1277, C1278, C1416) (from Aug 2014)C1417 High Power Supply Voltage Malfunction (from Aug 2014) →