2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

E200370E01
  1. Put protective tape around the door scuff plate assembly RH.

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate assembly RH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE COWL SIDE TRIM BOARD RH

E200371
  1. Remove the clip.

  1. Detach the clip and claw and remove the cowl side trim board RH.


4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Remove the screw.

  1. Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

    B298555E01

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD


5. REMOVE INSTRUMENT SIDE PANEL RH

B238212E01
  1. Put protective tape around the instrument side panel.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

  1. Disconnect the connector and remove the instrument side panel.


6. REMOVE INSTRUMENT PANEL ORNAMENT

B238217E01
  1. Put protective tape around the instrument panel ornament.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.


7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

B238219E01
  1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

    Text in Illustration 
    *1
    Bolt
    *2
    Screw

  1. Detach the 5 clips and claw.

  1. Disconnect each connector and remove the glove compartment door.


8. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

  1. E204225
    Remove the screw.

  1. Detach the 2 claws and remove the No. 2 air duct sub-assembly.


9. REMOVE ECU INTEGRATION BOX RH

B240503
  1. Disconnect the connectors.

  1. Detach the clamp.

  1. Remove the 2 nuts, bolt and ECU integration box RH.


10. REMOVE AIR CONDITIONER AMPLIFIER ASSEMBLY

B240505
  1. Detach the 2 claws and remove the air conditioner amplifier assembly.

← REMOVAL (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →