2013-2015 Land Cruiser Prado · Service Manual Steering

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
  1. Using a center punch, mark the center of the tapered-head bolt.

  1. Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the bolt.

  1. C215853E01
    Using a screw extractor, remove the bolt and steering lock actuator assembly from the steering column assembly.
    Text in Illustration 
    *A
    w/o Entry and Start System
    *B
    w/ Entry and Start System


2. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
  1. Turn the ignition switch to ON (ACC).

  1. C128808E02
    Insert the tip of a screwdriver into the hole in the steering column upper bracket, as shown in the illustration, and pull the ignition switch lock cylinder out until its claw comes into contact with the stopper of the steering column upper bracket.
    Text in Illustration 
    *1
    Claw
    *2
    Stopper
    *a
    Push
    *b
    Pull

    NOTICE:
    Pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the steering column bracket assembly upper. Otherwise, the following procedure cannot be conducted properly.

  1. C128809E04
    Insert the tip of a screwdriver into the hole in the steering column bracket and tilt it downward, as shown in the illustration, to disengage the claw of the ignition switch lock cylinder. Then pull out the ignition switch lock cylinder.
    Text in Illustration 
    *1
    Stopper
    *2
    Claw
    *a
    Tilt
    *b
    Pull out
    *c
    Claw is disengaged
    *d
    Driver insertion hole


3. REMOVE UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

  1. C128810
    Push up the unlock warning switch center portion to disengage the 2 claws.

    HINT:
    Slide the unlock warning switch in the direction shown by the arrow in the illustration to remove it.


4. REMOVE KEY INTERLOCK SOLENOID (w/o Entry and Start System for Automatic Transmission)
  1. Disconnect the connector.

  1. C128811
    Remove the 2 screws and remove the key interlock solenoid from the steering column upper bracket.


5. REMOVE IGNITION SWITCH ASSEMBLY (w/o Entry and Start System)

  1. C128812
    Remove the 2 screws and remove the ignition switch from the steering column upper bracket.


6. REMOVE KEY INTERLOCK SOLENOID WIRE (w/o Entry and Start System)
  1. Remove the key interlock solenoid wire from the ignition switch.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →