2013-2015 Land Cruiser Prado · Service Manual Steering

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL KEY INTERLOCK SOLENOID WIRE (w/o Entry and Start System)
  1. Install the key interlock solenoid wire on to the install the ignition switch.


2. INSTALL IGNITION SWITCH ASSEMBLY (w/o Entry and Start System)

  1. C128812
    Install the ignition switch onto the steering column upper bracket with the 2 screws.


3. INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System for Automatic trans mission)

  1. C128811
    Install the key interlock solenoid onto the steering column upper bracket with the 2 screws.

  1. Connect the connector.


4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

  1. C128815
    Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.

    HINT:
    Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.


5. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
  1. Turn the ignition switch to ON (ACC).

  1. C128816
    Install the ignition switch lock cylinder into the steering column upper bracket.

  1. Make sure that the ignition switch lock cylinder is securely fixed onto the ignition switch lock cylinder.


6. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)

  1. C128817
    Remove the key and check that the steering lock function is activated.

  1. C128818
    Insert the key, turn the ignition switch ON (ACC) and check that the steering lock function is deactivated.


7. INSTALL STEERING LOCK ACTUATOR ASSEMBLY
  1. Temporarily install the steering lock actuator assembly with a new tapered-head bolt.

  1. C215854E01
    Tighten the tapered-head bolt until the bolt head breaks off.
    Text in Illustration 
    *A
    w/o Entry and Start System
    *B
    w/ Entry and Start System

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →