2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE DEFOGGER RELAY (DEFOG)

B244733
  1. Remove the defogger relay from the main body ECU (instrument panel junction block).


INSPECT DEFOGGER RELAY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage not applied to terminals 1 and 2
    Below 1 Ω
    Battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.


INSTALL DEFOGGER RELAY
  1. Install the defogger relay to the main body ECU (instrument panel junction block).

← ON-VEHICLE INSPECTION (from Aug 2013)PRECAUTION (from Aug 2013) →