After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH
HINT:
Use the same procedure for the other front No. 1 assist grip plug.
Using a screwdriver, detach the 2 claws and remove the front No. 1 assist grip plug.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective Tape
4.
REMOVE NO. 1 ASSIST GRIP
HINT:
Use the same procedure for the other No. 1 assist grip.
Remove the 2 bolts.
Detach the 2 claws and remove the No. 1 assist grip.
5.
REMOVE FRONT PILLAR GARNISH LH
Detach the 3 guides and remove the front pillar garnish.
w/ Curtain Shield Airbag: Protect the curtain shield airbag assembly.
Completely cover the airbag with a cloth or nylon sheet and secure the ends of the cover with adhesive tape as shown in the illustration.
NOTICE:
Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.
Text in Illustration
*1
Curtain Shield Airbag Assembly
*2
Adhesive Tape
*3
Protective Cover
6.
REMOVE FRONT NO. 3 SPEAKER ASSEMBLY
Disconnect the connector.
Detach the clip and claw and remove the front No. 3 speaker.