2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

Rain Sensor LIN Communication Malfunction

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the auto wiper system is operated, the windshield wiper switch assembly uses LIN communication to communicate with the rain sensor. If the auto wiper system does not operate properly, a problem with the LIN communication between the windshield wiper switch assembly and rain sensor may be causing the malfunction.

WIRING DIAGRAM

C217430E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY - RAIN SENSOR)
  1. Disconnect the G120 windshield wiper switch assembly connector.

  1. Disconnect the W6 rain sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G120-5 (MPX1) - W6-3 (MPX)
    Always
    Below 1 Ω
    G120-5 (MPX1) or W6-3 (MPX) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

Go to WIPER AND WASHER SYSTEM (Click here)


← B2789 No Response from ID BOX (from Aug 2014)Rain Sensor LIN Communication Malfunction (from Aug 2014) →