C1442 Invalid Data Received from Acceleration Sensor
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Also covers:
- C1443 Invalid Data Received from Yaw Rate Sensor
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.The yaw rate and acceleration sensor has a built-in acceleration sensor and detects the vehicle condition.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1442 |
An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. |
Yaw rate and acceleration sensor |
| C1443 |
An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more. |
Yaw rate and acceleration sensor |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and acceleration sensor, perform calibration (Click here).
| 1. CHECK DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
