2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL CENTER CLUSTER MODULE PANEL
  1. Install the center cluster module panel to the center cluster module switch (rear differential lock control switch) with the 4 screws.


2. INSTALL CENTER CLUSTER MODULE SWITCH (REAR DIFFERENTIAL LOCK CONTROL SWITCH)
  1. Connect the connector.

  1. Attach the 3 clips and install the center cluster module switch (rear differential lock control switch) with the 2 bolts.


3. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
  1. w/o Seat Heater System:

    1. Connect the connector.

    2. Attach the 5 clips to install the front console upper panel garnish.

  1. w/o CRAWL:

    1. Connect each connector.

    2. Attach the 5 clips to install the front console upper panel garnish.

  1. w/ CRAWL:

    1. Attach the 5 clips to install the front console upper panel garnish.


4. INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

HINT:
Use the same procedure described for the No. 2 instrument panel finish panel cushion.


5. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
  1. Attach the 5 clips to install the No. 2 instrument panel finish panel cushion.


6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
  1. Attach the 4 clips to install the instrument panel finish panel end LH.


7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
  1. Attach the 4 clips to install the instrument panel finish panel end RH.


8. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
  1. Connect the connector.

  1. Attach the 4 clips to install the integration control and panel assembly.

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →