2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

  1. E283079
    Detach the 4 clips.

  1. Disconnect the connector and remove the integration control and panel assembly.


2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

B356216
  1. Detach the 4 clips and remove the instrument panel finish panel end LH.


3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

B356217
  1. Detach the 4 clips and remove the instrument panel finish panel end RH.


4. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

HINT:
Use the same procedure described for the No. 2 instrument panel finish panel cushion.


5. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

B356215
  1. Detach the 5 clips and remove the No. 2 instrument panel finish panel cushion.


6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH

  1. w/o Seat Heater System:

    1. B357641E01
      Put protective tape around the front console upper panel garnish.
      Text in Illustration 
      *1
      Protective Tape

    2. Detach the 5 clips and remove the front console upper panel garnish.

    3. Disconnect the connector.

  1. w/o CRAWL:

    1. B357639E01
      Put protective tape around the front console upper panel garnish.
      Text in Illustration 
      *1
      Protective Tape

    2. Detach the 5 clips and remove the front console upper panel garnish.

    3. Disconnect each connector.

  1. w/ CRAWL:

    1. B357640E01
      Put protective tape around the front console upper panel garnish.
      Text in Illustration 
      *1
      Protective Tape

    2. Detach the 5 clips and remove the front console upper panel garnish.


7. REMOVE CENTER CLUSTER MODULE SWITCH (REAR DIFFERENTIAL LOCK CONTROL SWITCH)

  1. C292496
    Remove the 2 bolts.

  1. Detach the 3 clips.

  1. Disconnect the connector and remove the center cluster module switch (rear differential lock control switch).


8. REMOVE CENTER CLUSTER MODULE PANEL

  1. C292495
    Remove the 4 screws and center cluster module panel from the center cluster module switch (rear differential lock control switch).

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →