2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Attach the 2 claws to install a new stop light switch mounting adjuster.


2. INSTALL STOP LIGHT SWITCH ASSEMBLY

E277439E01
  1. Install the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

    NOTICE:
    Do not depress the brake pedal.

    Text in Illustration 
    *1
    Brake Pedal
    *2
    Stop Light Switch Mounting Adjuster
    *3
    Stop Light Switch Assembly

  1. E277440E02
    Rotate the stop light switch assembly clockwise so that the clearance is between 1.5 and 2.5 mm (0.0590 and 0.0984 in.) as shown in the illustration.
    Text in Illustration 
    *1
    Shaft
    *2
    Stop Light Switch Assembly
    *a
    1.5 to 2.5 mm

    NOTICE:
    Do not depress the brake pedal.

  1. Check the stop light switch assembly clearance.

    Stop light switch assembly clearance:
    1.5 to 2.5 mm (0.0590 to 0.0984 in.)

  1. Connect the connector to the stop light switch assembly.


3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. for LHD:

    1. Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.

    2. Install the screw.

  1. for RHD:

    1. Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.

    2. Install the screw.

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →