2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT STOP LIGHT SWITCH ASSEMBLY

E270964E02
  1. Disconnect the stop light switch assembly connector.

  1. Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (B) - 3 (GND)
    Engine switch off
    11 to 14 V
    5 (B) - 3 (GND)
    Engine switch on (IG)
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (GND) - Body ground
    Always
    Below 1 Ī©

    If the result is not as specified, repair or replace the wire harness or connector.
    Text in IllustrationĀ 
    *a
    Front view of wire harness connector
    (to Stop Light Switch Assembly)

  1. Reconnect the stop light switch assembly connector.

  1. E240777E05
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (L) - 3 (GND)
    Engine switch off, brake pedal not depressed
    Below 1 V
    2 (L) - 3 (GND)
    Engine switch off, brake pedal depressed
    11 to 14 V
    4 (L) - 3 (GND)
    Engine switch on (IG), brake pedal not depressed
    11 to 14 V
    4 (L) - 3 (GND)
    Engine switch on (IG), brake pedal depressed
    Below 1 V

    If the result is not as specified, replace the stop light switch assembly.
    Text in IllustrationĀ 
    *a
    Component with harness connected
    (Stop Light Switch Assembly)

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →